Enterasys D2 D2G124-12P

set linkflap downtime
D-Series CLI Reference 4-27
set linkflap downtime
Usethiscommandtosetthetimeinterval(inseconds)oneormoreportswillbehelddownaftera
linkflapviolation.
Syntax
set linkflap downtime port-string downtime-value
Parameters
Defaults
None.
Mode
Switchmode,read‐write.
Example
Thisexampleshowshowtosetthelinkflapdowntimeonportge.1.4to5000seconds.
D2(rw)->set linkflap downtime ge.1.4 5000
clear linkflap down
Usethiscommandtotogglelinkflapdisabledportstooperational.
Syntax
clear linkflap down [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,allportsdisabledbyalinkflapviolationwillbemadeoperational.
Mode
Switchmode,read‐write.
Example
Thisexampleshowshowtomakedisabledportge.1.4operational.
D2(rw)->clear linkflap down ge.1.4
port‐string Specifiestheport(s)onwhichtosetthelinkflapdowntime.
downtime‐value Specifiesadowntimeinseconds.Avalueof0 willsetthedowntimeto
forever.
port‐string (Optional)Specifiestheportstomakeoperational.