Enterasys D2 D2G124-12P

D-Series CLI Reference 3-1
3
Discovery Protocol Configuration
Thischapterdescribeshowtoconfigurediscoveryprotocols.
Configuring CDP
Purpose
ToreviewandconfiguretheEnterasysCDPdiscoveryprotocol.Thisprotocolisusedtodiscover
networktopology.Whenenabled,thisprotocolallowsEnterasysdevicestosendperiodicPDUs
aboutthemselvestoneighboringdevices.
Commands
ThecommandsusedtoreviewandconfiguretheCDPdiscoveryprotocolarelistedbelow.
show cdp
UsethiscommandtodisplaythestatusoftheCDPdiscoveryprotocolandmessageintervalon
oneormoreports.
Syntax
show cdp [port-string]
For information about... Refer to page...
Configuring CDP 3-1
Configuring Cisco Discovery Protocol 3-6
For information about... Refer to page...
show cdp 3-1
set cdp state 3-3
set cdp auth 3-3
set cdp interval 3-4
set cdp hold-time 3-5
clear cdp 3-5
show neighbors 3-6