Enterasys D2 D2G124-12P

clear spantree lplock
6-42 Spanning Tree Configuration
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLoopProtectlockstatusonge.1.1:
D2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port ge.1.1 , SID 0 is UNLOCKED
clear spantree lplock
Usethiscommandtomanuallyunlockablockedportandoptionally,perSID.Thedefaultstateis
unlocked.
Syntax
clear spantree lplock port-string [sid sid]
Parameters
Defaults
IfnoSIDisspecified, SID0isassumed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtoclearLoopProtectlockfromge.1.1:
D2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port ge.1.1 , SID 0 is LOCKED
D2(rw)->clear spantree lplock ge.1.1
D2(rw)->show spantree lplock port ge.1.1
The LoopProtect lock status for port ge.1.1 , SID 0 is UNLOCKED
set spantree lpcapablepartner
UsethiscommandtospecifyperportwhetherthelinkpartnerisLoopProtectcapable.See“Loop
Protect”onpage 2.formoreinformation.
Syntax
set spantree lpcapablepartner port-string {true | false}
Parameters
port‐string Specif iesport(s)forwhichtocleartheLoopProtectlock.
sidsid (Optional)SpecifiesthespecificSpanningTree(s)forwhichtoclearthe
LoopProtectlock.Validvaluesare0‐4094.Ifnotspecified,SID0is
assumed.
port‐string Specif iesport(s)forwhichtoconfigureaLoopProtectcapablelink
partner.