Enterasys D2 D2G124-12P

Configuring SNMP Notification Parameters
5-28 SNMP Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearSNMPtargetaddressentry“tr”:
D2(su)->clear snmp targetaddr tr
Configuring SNMP Notification Parameters
About SNMP Notify Filters
ProfilesindicatingwhichtargetsshouldnotreceiveSNMPnotificationmessagesarekeptinthe
NotifyFiltertable.Ifthistableisempty,meaningthatnofilteringisassociatedwithanySNMP
target,thennofilteringwilltakeplace.“Traps”or“informs”notificationswillbesenttoall
destinationsintheSNMPtargetAddrTable
thathavetagsmatchingthosefoundinthe
NotifyTable.
WhentheNotifyFiltertablecontainsprofileentries,theSNMPagentwillfindanyfilterprofile
namethatcorrespondstothetargetparameternamecontainedinanoutgoingnotification
message.Itwillthenapplytheappropriatesubtree‐specificfilterwhengeneratingnotification
messages.
Purpose
ToconfigureSNMPnotificationparametersandoptionalfilters.Notificationsareentitieswhich
handlethegenerationofSNMPv1andv2“traps”orSNMPv3“informs”messagestoselect
managementtargets.Optionalnotificationfiltersidentifywhichtargetsshouldnotreceive
notifications.ForasampleSNMPtrapconfigurationshowinghowSNMPnotificationparameters

areassociatedwithsecurityandauthorization criteria(targetparameters)andmappedtoa
managementtargetaddress,referto“CreatingaBasicSNMPTrapConfiguration”onpage 5‐37.
Commands
targetAddr Specifiesthetargetaddressentrytodelete.
For information about... Refer to page...
show newaddrtrap 5-29
set newaddrtrap 5-30
show snmp notify 5-30
set snmp notify 5-31
clear snmp notify 5-32