Enterasys D2 D2G124-12P - Clear Dhcp Pool Lease; Set Dhcp Pool Default-Router

clear dhcp pool lease
D-Series CLI Reference 14-21
Defaults
Ifnoleasetimeisspecified,aleasedurationof1dayisconfigured.
Mode
Switchcommand,read‐write.
Example
Thisexampleconfiguresaleasedurationof12hoursfortheaddresspoolbeingconfigured.Note
thattoconfigurealeasetimelessthanoneday,enter0fordays,thenthenumberofhoursand
minutes.
D2(rw)->set dhcp pool auto1 lease 0 12
clear dhcp pool lease
Usethiscommandtorestorethedefaultleasetimevalueofonedayfortheaddresspoolbeing
configured.
Syntax
clear dhcp pool poolname lease
Parameters
Defaults
Clearstheleasetimeforthisaddresspooltothedefaultvalueofoneday.
Mode
Switchcommand,read‐write.
Example
Thisexamplerestoresthedefaultleasedurationofonedayforaddresspool“auto1.”
D2(rw)->clear dhcp pool auto1 lease
set dhcp pool default-router
UsethiscommandtospecifyadefaultrouterlistfortheDHCPclientsservedbytheaddresspool
beingconfigured.Upto8defaultrouterscanbeconfigured.
hours (Optional)Whenadaysvaluehasbeenassigned,specifiesthenumberof
hoursanaddressleasewillremainvalid.Valuecanrangefrom
0to1439.
minutes (Optional)Whenadaysvalueandanhoursvaluehavebeenassigned,
specifiesthenumberofminuteanaddressleasewillremainvalid.Value
canrangefrom0to86399.
infinite Specif iesthatthedurationoftheleasewillbeunlimited.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.