Enterasys D2 D2G124-12P - Clear Dhcp Pool Netbios-Name-Server

clear dhcp pool netbios-name-server
D-Series CLI Reference 14-25
Syntax
set dhcp pool poolname netbios-name-server address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleassignsaNetBIOSnameserverat10.15.10.1totheaddresspoolbeingconfigured.
D2(rw)->set dhcp pool auto1 netbios-name-server 10.15.10.1
clear dhcp pool netbios-name-server
UsethiscommandtoremovetheNetBIOSnamerserverlistfromtheaddresspoolbeing
configured.
clear dhcp pool poolname netbios-name-server
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleremovestheNetBIOSnameserverlistfromtheaddresspoolauto1.
D2(rw)->clear dhcp pool auto1 netbios-name-server
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressofaNetBIOSnameserver.
address2...address8 (Optional)Specifies,inorderofpreference,upto7additionalNetBIOS
nameserveraddresses.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.