Enterasys D2 D2G124-12P - Clear License; Configuring System Power and Power over Ethernet (Poe); Purpose

clear license
2-30 Basic Configuration
Usage
Licensescanbedisplayed,applied,andclearedonlywiththelicensecommandsdescribedinthis
chapter.Generalconfigurationcommandssuchasshowconfigorclearconfigdonotaffect
licenses.
Example
Thisexampleshowshowtodisplaylicensekeyinformation.
D2(ro)->show license
key: INCREMENT D2Policy 2006.0728 permanent 31173CAC6495 045100039001
status: Active
clear license
Usethiscommandtoclearthelicensekeysettings..
Syntax
clear license featureId feature
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheD2Policylicensedfeatu re:
D2(rw)->clear license featureId D2Policy
Configuring System Power and Power over Ethernet (PoE)
Purpose
ToreviewandsetsystempowerandPoEparameters,includingthepoweravailabletothesystem,
theusagethresholdforeachmodule,whetherornotSNMPtrapmessageswillbesentwhen
powerstatuschanges,andper‐portPoEsettings.
featureIDfeature Thenameofthefeaturebeingcleared.
Important Notice
Some commands in this section apply only to PoE-equipped D-Series devices. Consult the Installation Guide
shipped with your product to determine if it is PoE-equipped.