Enterasys D2 D2G124-12P

clear port broadcast
4-30 Port Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Perportbroadcastsuppressionishardsettobegloballyenabledonthe D2.Ifyouwouldliketo
disablebroadcastsuppression,youcangetthesameresultbysettingthethresholdlimitforeach
porttothemaximumnumberofpacketswhichcanbereceived persecondaslistedinthe

parameterssection,above.Thedefaultbroadcastsuppressionthresholdforallportsissetto
14881.
Example
Thisexampleconfiguresports1through5withabroadcastlimitof50pps:
D2(su)->set port broadcast ge.1.1-5 50
clear port broadcast
Usethiscommandtoclearthebroadcastthresholdlimittothedefaultvalueof14881forthe
selectedport.
Syntax
clear port broadcast port-string threshold
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleclearsthebroadcastthresholdlimitto14881ppsforports1through5:
D2(su)->clear port broadcast ge.1.1-5 threshold
port‐string Selecttheportsforwhichtoclearbroadcastsuppressionthresholds.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage4‐1.