Enterasys D2 D2G124-12P

Packet Capture Commands
13-20 RMON Configuration
Packet Capture Commands
Notethatpacketcapturefilterissamplingonlyanddoesnotguaranteereceiptofback‐to‐back
packets.
Purpose
TodisplayRMONcaptureentries,configure,enable,ordisablecaptureentries,andclearcapture
entries.
Commands
show rmon capture
UsethiscommandtodisplayRMONcaptureentriesandassociatedbuffercontrolentries.
Syntax
show rmon capture [index [nodata]]
Parameters
Defaults
Ifnooptionsarespecified,allbuffercontrolentriesandassociatedcapturedpacketswillbe
displayed.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show rmon capture 13-20
set rmon capture 13-21
clear rmon capture 13-22
index (Optional)Displaysthespecifiedbuffercontrolentryandallcaptured
packetsassociatedwiththatentry.
nodata (Optional)Displaysonlythebuffercontrolentryspecifiedbyindex.