Enterasys D2 D2G124-12P User Manual

set spantree
D-Series CLI Reference 6-7
set spantree
UsethiscommandtogloballyenableordisabletheSpanningTreeprotocolontheswitch.
Syntax
set spantree {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisableSpanningTreeonthedevice:
D2(su)->set spantree disable
show spantree version
UsethiscommandtodisplaythecurrentversionoftheSpanningTreeprotocolrunning onthe
device.
Syntax
show spantree version
Parameters
None.
Defaults
None.
Bridge Forward Delay Amount of time (in seconds) the bridge spends in listening or learning
mode. This is a default value, or is assigned using the set spantree
fwddelay command. For details, refer to “set spantree fwddelay” on
page 6-20.
Topology Change Count Number of times topology has changed on the bridge.
Time Since Top Change Amount of time (in days, hours, minutes and seconds) since the last
topology change.
Max Hops Maximum number of hops information for a particular Spanning Tree
instance may traverse (via relay of BPDUs within the applicable MST
region) before being discarded.
Table 6-28 show spantree Output Details (Continued)
Output What It Displays...
disable|enable GloballydisablesorenablesSpanningTree.

Enterasys D2 D2G124-12P Specifications

General

Brand	Enterasys
Model	D2 D2G124-12P
Category	Network Router
Language	English