Enterasys D2 D2G124-12P

clear cos settings
D-Series CLI Reference 9-21
Example
ThisexampleshowshowtocreateCoSentry8withapriorityvalueof3:
D2(rw)->set cos settings 8 priority 3
clear cos settings
UsethiscommandtoclearClassofServiceentrysettings.
Syntax
clear cos settings cos-list {[all] | [priority] [tos-value] [irl-reference]}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearthepriorityforCoSentry8:
D2(rw)->clear cos settings 8 priority
show cos settings
UsethiscommandtodisplayClassofServiceparameters.
Syntax
show cos settings [cos-list]
Parameters
Defaults
Ifnotspecified,allCoSentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
cos‐list SpecifiesaClassofServiceentrytoclear.
all Clearsallsettingsassociatedwiththisentry.
priority Clearsthepriorityvalueassociatedwiththisentry.
tos‐value ClearstheTypeofServicevalueassociatedwiththisentry.
irl‐reference CleartheIRLreferenceassociatedwiththisentry.
cos‐list (Optional)SpecifiesaClassofServiceentrytodisplay.