Enterasys D2 D2G124-12P

set igmpsnooping adminmode
D-Series CLI Reference 11-3
Usage
ConfiguredinformationisdisplayedwhetherornotIGMPsnoopingisenabled.Status
informationisdisplayedonlywhenthefunctionisenabled.Forinformationonenabling IGMPon
thesystem,referto“setigmpsnoopingadminmode”onpage 11‐3.Forinformationonenabling
IGMPononeormoreports,referto“
setigmpsnoopinginterfacemode”onpage 11‐4.
Example
ThisexampleshowshowtodisplayIGMPsnoopinginformation:
D2(su)->show igmpsnooping
Admin Mode..................................... Enable
Group Membership Interval...................... 260
Max Response Time.............................. 100
Multicast Router Present Expiration Time....... 0
Interfaces Enabled for IGMP Snooping........... ge.1.1,ge.1.2,ge.1.3
Multicast Control Frame Count..................0
Data Frames Forwarded by the CPU...............0
set igmpsnooping adminmode
UsethiscommandtoenableordisableIGMPonthesystem.
Syntax
set igmpsnooping adminmode {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
InorderforIGMPsnoopingtobeenabledononeorallports,itmustbegloballyenabledonthe
devicewiththiscommand,andthenenabledonaport(s)usingthesetigmpsnoopinginterface
modecommandasdescribedin“setigmpsnoopinginterfacemode”onpage 11‐4.
Example
ThisexampleshowshowtoenableIGMPonthesystem:
D2(su)->set igmpsnooping adminmode enable
enable|disable EnablesordisablesIGMPsnoopingonthesystem.
Note: IGMP snooping cannot be controlled via WebView.