Enterasys D2 D2G124-12P

set igmpsnooping maxresponse
D-Series CLI Reference 11-5
Usage
TheIGMPgroupmembershipintervaltimesetsthefrequencyofhost‐queryframetransmissions
andmustbegreaterthantheIGMPmaximumresponsetimeasdescribedin“setigmpsnooping
maxresponse”onpage 11‐5.
Example
ThisexampleshowshowtosettheIGMPgroupmembershipintervalto250seconds:
D2(su)->set igmpsnooping groupmembershipinterval 250
set igmpsnooping maxresponse
UsethiscommandtoconfiguretheIGMPquerymaximumresponsetimeforthesystem.
Syntax
set igmpsnooping maxresponse time
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ThisvaluemustbelessthantheIGMPmaximumresponsetimedescribedin“setigmpsnooping
groupmembershipinterval”onpage 11‐4.
Example
ThisexampleshowshowtosettheIGMPmaximumresponsetimeto100seconds:
D2(su)->set igmpsnooping maxresponse 100
set igmpsnooping mcrtrexpiretime
UsethiscommandtoconfiguretheIGMPmulticastrouterexpirationtimeforthesystem.
Syntax
set igmpsnooping mcrtrexpire time
time SpecifiestheIGMPmaximumqueryresponsetime.Validvaluesare100‐
255seconds.Thedefaultvalueis100seconds.
Thisvalueworkstogetherwiththesetigmpsnooping
groupmembershipintervalcommandtoremoveportsfromanIGMPgrou p
andmustbelesserthanthegroupmembershipintervalvalue.