Enterasys D2 D2G124-12P

clear lacp static
D-Series CLI Reference 4-41
clear lacp static
UsethiscommandtoremovespecificportsfromaLinkAggregation Group.
Syntax
clear lacp static lagportstring port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoremovege.1.6fromtheLAGofaggregatorport6:
D2(su)->clear lacp static lag.0.6 ge.1.6
set lacp singleportlag
UsethiscommandtoenableordisabletheformationofsingleportLAGs.
Syntax
set lacp singleportlag {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
WhensingleportLAGsareenabled,LinkAggregrationGroupscanbeformedwhenonlyone
portisreceivingprotocoltransmissionsfromapartner.Whenthissettingisdisabled,twoormore
portsarerequiredtoformaLAG.
ThissettinghasnoeffectonexistingLAGscreatedwithmultiplememberports.
Italsodoesnot
preventpreviouslyformedLAGsfromcomingupaftertheyhavegonedown,aslongasany
lagportstring SpecifiestheLAGaggregatorportfromwhichportswillberemoved.
port‐string Specifiestheport(s) toremovefromtheLAG.Foradetaileddescriptionof
possibleport‐stringvalues,refer
to“PortStringSyntaxUsedintheCLI”
onpage4‐1.
disable|enable EnablesordisablestheformationofsingleportLAGs.