Enterasys D2 D2G124-12P

show policy maptable response
15-42 Security Configuration
Commands
show policy maptable response
Displaysthecurrentpolicymaptableresponsesetting.WhenVLANauthorizationisenabled(as
describedinthissection)andthepolicymaptableresponseistunnel,youcanusetheset
multiauthportcommand(page15‐34)tosetthenumberofRFC3580users(numusers)allowed
perGigabitport.
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythecurrentpolicymaptableresponsesetting:
D2(rw)->show policy maptable response
policy
set policy maptable response
SetsthemaptableresponsefromthedefaultofpolicytotunneltoallowuptoVLANauthorized
userstobeconfiguredperGigabitport.
Syntax
set policy maptable response {policy | tunnel}
For information about... Refer to page...
show policy maptable response 15-42
set policy maptable response 15-42
set vlanauthorization 15-43
set vlanauthorization egress 15-44
clear vlanauthorization 15-44
show vlanauthorization 15-45