Enterasys D2 D2G124-12P

set port protected name
D-Series CLI Reference 4-49
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearprotectedportsge.1.1throughge.1.3:
D2(rw)->clear port protected ge.1.1-3
set port protected name
Usethiscommandtoassignanametoaprotectedportgroupid.
Syntax
set port protected name group-id name
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoassignthename“group1”toprotectedportgroup1:
D2(rw)->set port protected name 1 group1
show port protected name
Usethiscommandtodisplaythenameforthegroupidsspecified.
Syntax
show port protected name group-id
Parameters
Defaults
None.
Mode
Read‐only.
group‐id Specifiestheidofthisgroup.Idcanrangefrom0to2.
name Specifiesanameforthegroup.Thenamecanbeupto32charactersin
length.
group‐id Specifiestheidofthegrouptodisplay.Idcanrangefrom0to2.