Enterasys D2 D2G124-12P

Resetting the Switch
2-50 Basic Configuration
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Bydefault,switchtimeoutoccursafter15minutesofuserinactivity, automaticallyclosingyour
CLIsession.Usethesetlogoutcommand(page2‐26)tochangethisdefault.
Example
ThisexampleshowshowtoexitaCLIsession:
D2(su)->exit
Resetting the Switch
Purpose
Toresetoneormoreswitches,andtocleartheuser‐definedconfigurationparameters.
Commands
reset
Usethiscommandtoresettheswitchwithoutlosinganyuser‐definedconfigurationsettings.
Syntax
reset
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
reset 2-50
clear config 2-51