Enterasys D2 D2G124-12P

show dot1x
15-10 Security Configuration
show dot1x
Usethiscommandtodisplay802.1Xstatus,diagnostics,statistics,andreauthenticationor
initializationcontrolinformationforoneormoreports.
Syntax
show dot1x [auth-diag] [auth-stats] [port [init | reauth]] [port-string]
Parameters
Defaults
Ifnoparametersarespecified,802.1Xstatuswillbedisplayed.
Ifport‐stringisnotspecified,informationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
show eapol 15-16
set eapol 15-17
clear eapol 15-18
For information about... Refer to page...
auth‐diag (Optional)Displaysauthenticationdiagnosticsinformation.
auth‐stats (Optional)Displaysauthenticationstatistics.
portinit|reauth (Optional)Displaysthestatusofportinitializationandreauthentication
controlfortheport.
port‐string (Optional)Displaysinformationforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
in
theCLI”onpage 4‐1.