Enterasys D2 D2G124-12P

show dhcp pool configuration
14-28 DHCP Server Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesoption19fromaddresspool“auto1.”
D2(rw)->clear dhcp pool auto1 option 19
show dhcp pool configuration
Usethiscommandtodisplayconfigurationinformationforoneoralladdresspools.
Syntax
show dhcp pool configuration {poolname | all}
Parameters
Defaults
None.
Mode
Read‐only.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
code SpecifiestheDHCPoptioncode,asdefinedinRFC2132.Valuecanrange
from1to254.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.