Konica Minolta CS-7 - Page 395

395
10.2 Error codes and countermeasures
Chapter 10
Error code Displayed message Problems/countermeasures
F3800*
F3801*
[DR Detector name] internal error
If the panel after rebooting does not recover, contact a
service representative.
(1) Restart the DR Detector.
(2) Contact Konica Minolta technical representatives.
F3802*
F3803*
F3804*
[DR Detector name] wired LAN error
If the panel after rebooting does not recover, contact a
service representative.
F39***
[DR Detector name] radio error
Temporarily wireless status became worse.
(1) Restart the DR Detector.
(2) Contact Konica Minolta technical representatives.
Wireless connection cannot be used, but continued
operation is possible with the wired connection.
F3C00*
[DR Detector name] internal error
If the panel after rebooting does not recover, contact a
service representative.
(1) Restart the DR Detector.
(2) Contact Konica Minolta technical representatives.
F3C11*
F3C12*
[DR Detector name] internal error
If the panel after rebooting does not recover, contact a
service representative.
F3J00*
[DR Detector name] radio error
Temporarily wireless status became worse.
(1) Restart the DR Detector.
(2) Contact Konica Minolta technical representatives.
Wireless connection cannot be used, but continued
operation is possible with the wired connection.
F3K24*
[DR Detector name] network error
IP address is already in use for another device.
Contact a service representative.
Contact Konica Minolta technical representatives.
F3L27*
[DR Detector name] internal error
If the panel after rebooting does not recover, contact a
service representative.
(1) Restart the DR Detector.
(2) Contact Konica Minolta technical representatives.
F3P00*
[DR Detector name] internal error
If the panel after rebooting does not recover, contact a
service representative.
F3Y00*
F3Z02*
[DR Detector name] internal error
If the panel after rebooting does not recover, contact a
service representative.
F4I32*
[DR Detector name] holding the power switch down
error
The panel's power switch is held down.
please release the power switch.
The power switch of the DR Detector is pressed and
held for 30 seconds or longer.
Release the power switch.
F4I33*
[DR Detector name] holding the power switch down
error
The panel's power switch is held down.
please release the power switch.
The selection switch of the DR Detector is pressed and
held for 30 seconds or longer.
Release the selection switch.