Introduction
This instructional manual contains information on the FD75 FlexDraper
®
and the CA25 Combine Adapter. It must
be used in conjunction with your combine operator's manual.
The FD75 FlexDraper
®
is specially designed as a “straight cut” header and is e quipped to work w ell in all straight
cut conditions, whether cutting on or above the ground, using a three-piece flexible fram e to close ly follow
ground contours.
CAREFULLY READ ALL THE MATERIAL PROVIDED BEFORE ATTEMPTING TO UNLOAD, ASSEMBLE, OR USE
THE MACHINE.
Use this manual as your first source of information about the machine. If you follow the instructions given here,
your header will work well for many years. If you require more detailed service information, a technical manual is
available from your MacDon Dealer.
The Table of Contents an d Index will guide you to specific areas of this manual. Study the Table of Contents to
familiarize yourself with how the information is organized.
Keep this manual handy for frequent reference and to pass
on to new Operators or Owners. A storage case for this
manual is located inside the header left endshield.
Call your MacDon Dealer if you need assistance,
information, or additional copies of this manual.
NOTE:
Keep your
MacDon publications up-to-date. The
most cur
rent version can be downloaded from our
website
(www.macdon.com) or from our Dealer-only site
(https:
//portal.macdon.com ) (login required).
This manual is also available in the following languages:
•French
•Russia
n
•Portug
uese
• Spani
sh
They c
an be ordered from MacDon, downloaded from
the D e
aler Port al (https://portal.macdon.com)orfromour
Inter
national website (http://www.macdon.com/world).
Figure 1: Manual Storage Location
147695
i
ii
Revision A
To Next Page
Loading...
