MacDon FFT FlexDraper FD75 - Page 6

List of Revisions
The following
lists the changes from the previous version (169894 Revision A) of this document.
Summary of Change Refer To
New Book Part Number
•FD75FlexDraper
®
Header Operator ’s Manual from
MD #196894_A to MD #147695_A
• 8.3 Unloading and Assembly, page 446
New Declaration of Conformity Declaration of Conformity, page i
Added a step in Calibrating the Auto Header Height
Control
• Calibrating the Auto Header Height Control
(Challenger 6 Series), page 97
• Calibrating the Auto Header Height Control
(Case IH 2300/2500 and 5088/6088/7088), page 103
• Calibrating the Auto Header Height Control (Case
IH 5130/6130/7130, 7010/8010; 7120/8120/9120;
7230/8230/9230), page 110
• Calibrating the Auto Header Height Control System
(Case Combines with Version 28.00 Software), page
112
• Calibrating the Auto H eader Height Control (Gleaner
R62/R72), page 114
• Calibrating the Auto H eader Height Control (Gleaner
R65/R75), page 120
• Calibrating the Auto Header Height Control (John
Deere 50 Series), page 129
• Calibrating the Auto Header Height Control (John
Deere 60 Series), page 132
• Calibrating the Auto Header Height Control (John
Deere 70 Series), page 141
• Calibrating the Auto Header Height Control (John
Deere S Series), page 146
• Calibrating the Auto Header Height Control (Lexion
500 Series), page 150
• Calibrating the Auto Header Height Control (Lexion
700 Series), page 157
• Calibrating the Auto Header Height Control (New
Holland CR/CX Series), page 167
Added new kit
6.
1.1 Multi-Crop Rapid Reel Conversion Kit, page 407
Revised H eader Settings 3.6.2 Header Settings, page 44
147695
i
v
Revision A