Rohde & Schwarz RTP Series - Page 276

Waveform analysis
R&S
®
RTP
276User Manual 1337.9952.02 ─ 12
X start ← Start/Stop
Defines the lower limit of the zoom area on the x-axis.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:STARt on page 1321
LAYout:ZOOM:HORZ:RELative:STARt on page 1323
X stop ← Start/Stop
Defines the upper limit of the zoom area on the x-axis.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:STOP on page 1321
LAYout:ZOOM:HORZ:RELative:STOP on page 1323
Y start ← Start/Stop
Defines the lower limit of the zoom area on the y-axis.
Remote command:
LAYout:ZOOM:VERTical:RELative:STARt on page 1326
LAYout:ZOOM:VERTical:ABSolute:STARt on page 1324
Y stop ← Start/Stop
Defines the upper limit of the zoom area on the y-axis.
Remote command:
LAYout:ZOOM:VERTical:RELative:STOP on page 1326
LAYout:ZOOM:VERTical:ABSolute:STOP on page 1325
Position/Range
In the "Position/Range" tab, you specify the x and y position of center point of the zoom
area plus a range for the x- and y-axes; the area defined by that point and the ranges
is zoomed.
X position ← Position/Range
Defines the x-value of the centerpoint of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:POSition on page 1320
LAYout:ZOOM:HORZ:RELative:POSition on page 1322
SEARch:RESDiagram:HORZ:ABSolute:POSition on page 1511
SEARch:RESDiagram:HORZ:RELative:POSition on page 1512
Zoom