Remote Control Commands
R&S
®
SMBV100B
636User Manual 1178.4460.02 ─ 03
:DISPlay:PSAVe:HOLDoff <HoldoffTimeMin>
Sets the wait time for the screen saver mode of the display.
Parameters:
<HoldoffTimeMin> integer
Range: 1 to 60
*RST: n.a. (factory preset: 10)
Default unit: minute
Example: see Example "Activating screen saver mode and display update"
on page 635
Manual operation: See "Wait Time" on page 511
:DISPlay:PSAVe[:STATe]
<State>
Activates the screen saver mode of the display.
We recommend that you use this mode to protect the display, if you operate the instru-
ment in remote control.
To define the wait time, use the command :DISPlay:PSAVe:HOLDoff.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
Example: See Example "Activating screen saver mode and display
update" on page 635
Manual operation: See "Screen Saver" on page 511
:DISPlay:BRIGhtness <BRIGhtness>
Sets the brightness of the dispaly.
Parameters:
<BRIGhtness> float
Range: 1.0 to 20.0
Increment: 1.0
*RST: 14.0
Example:
DISPlay:BRIGhtness 14
Manual operation: See "Display" on page 511
:DISPlay:BUTTon:BRIGhtness <ButtonBrightnes>
Sets the brightness of the [RF on/off] key.
DISPlay Subsystem
To Next Page
Loading...
