Electronic gear numerator *3.
Electronic gear denominator *3.
Command mode selection *3
Feel length multiplication (STM)
(Multiplier)
0000 (<1000 stroke)/0001 (>1000 stroke)
Home position return method
-36 (Home position return direction: Motor side, Stopper type)
Home position return Speed (rpm)
Stopper type home position return
stopper time (msec)
Stopper type home position return torque
limit value (%)
Home position return acceleration
time constant (msec)
0000 (Non)/0002 (LEC-MR-RB-032)
Rotation direction selection
1 (+：
Counter
motors
side)
0 (+：
Counter
motors
side)
1 (+：
Counter
motors
side)
0 (+：
Counter
motors
side)
1 (+：
Counter
motors
side)
0 (+：
Counter
motors side)
★ Load to motor inertia moment ratio
0001(Robust filter enabled)
★ Parameter setting required.
*1. Parameter is set to the recommended value. Please set parameter according to customer application.
*2. Mechanical resonance may occur depending on the shape or mounting orientation of the work piece.
Please change this parameter during initial configuration.
(Parameter initial configuration ⇒ Set the recommended parameter value ⇒ Operation start)
*3. Minimum actuator travel distance of 1[μm].
When the stopper type home position return is used and the actuator end is set to
the home position, please pay attention to the actuator movable range when
commanding the position to prevent collision with both ends of the actuator due to
overshoot.
When the origin (0 mm) is set at the actuator end, the movable range of this
actuator is from [+3mm] to [actuator stroke +3mm].
To Next Page
Loading...
Need help?
General
