SMC Networks LECSN-T Series User Manual

8. TROUBLESHOOTING
8 - 17
Alarm No.: 14
Name: Control process error
Alarm content
・The process did not complete within the specified time.
Detail
No.
Detail name
Cause
Check method
Check result
Action
14.1
Control process
error 1
(1)
The parameter setting
is incorrect.
Check if the
parameter setting
is incorrect.
It is incorrect.
Set it correctly.
It is correct.
Check (3).
(2)
Something near the
device caused it.
Check the power
supply for noise.
Check if the
connector is
shorted
There is a problem in
the
surrounding.
Take countermeasures
against its cause.
There is no problem
in
the surrounding.
Check (4).
(3)
The driver is
malfunctioning.
Replace the driver,
and then check the
repeatability.
It is not repeatable.
Replace the driver.
14.2
Control process
error 2
(1)
The parameter setting
is incorrect.
Check if the
parameter
setting is incorrect.
It is incorrect.
Set it correctly.
It is correct.
Check (5).
(2)
Something near the
device caused it.
Check the power
supply for noise.
Check if the
connector is
shorted.
There is a problem in
the surrounding.
Take countermeasures
against its cause.
There is no problem
in the surrounding.
Check (6).
(3)
The driver is
malfunctioning.
Replace the driver,
and then check the
repeatability.
It is not repeatable.
Replace the driver.
14.3
Control process
error 3
Check it with the check method for [AL. 14.1].
14.4
Control process
error 4
14.5
Control process
error 5
14.6
Control process
error 6
14.7
Control process
error 7
14.8
Control process
error 8
14.9
Control process
error 9
14.A
Control process
error 10
14.B
Control process
error 11
(1)
The parameter setting
is incorrect.
Check if the
parameter
setting is incorrect.
It is incorrect.
Set it correctly.
It is correct.
Check (3).
(2)
Something near the
device caused it.
Check the power
supply
for noise. Check if
the connector is
shorted.
It has a failure.
Take countermeasures
against its cause.
It has no failure.
Check (4).
(3)
The driver is
malfunctioning
Replace the driver,
and then check
the repeatability.
It is not repeatable.
Replace the driver.
14.C
Control process
error 12
Check it with the check method for [AL. 14.B].
14.D
Control process
error 13

SMC Networks LECSN-T Series Specifications

General

Brand	SMC Networks
Model	LECSN-T Series
Category	Controller
Language	English