Xerox Phaser 4510 - Resetting Printer Values to the Factory Default Values; Resetting Connection Setup Values

6-10 Phaser 4500/4510 Service Manual
Adjustments and Calibrations
Resetting Printer Values to the Factory Default Values
You can reset printer values on the following menus to the factory default
settings:
■ Connection Setup
■ Paper Handling Setup
■ PostScript Setup
■ PCL Setup
■ General Setup
■ Control Panel Setup
■ Printer Controls
■ File Security (available if the printer has a hard drive)
You can reset all of the Image Processor Board NVRAM-stored parameters to
their factory default values by resetting the PostScript NVRAM. Instructions
for resetting PostScript NVRAM are in “Resetting All Printer Default Settings
(PostScript NVRAM)” on page 6-13.
N
o
t
e
There is no single reset for the Print Engine NVRAM.
Resetting Connection Setup Values
Resetting the connection setup values resets the Printer Name, TCP/IP
address, TCP/IP address menu settings (gateway, broadcast, etc.),
CentreWare IS, EtherTalk, NetWare, set IPX frame type, IPP, and Ethernet
speed to their default values.
Caution
Before resetting the connection setup values to factory default values,
make note of the current network settings or print a Configuration Page to
record the printer’s current network settings.
1. From the Main Menu, select Connection Setup, then press the OK
button.
2. Select Reset Connection Setup, then press the OK button.
3. Select Reset Connection Setup NOW, then press the OK button.