Xerox Phaser 4510 - Feed Clutch

Phaser 4500/4510 Service Manual 8-29
FRU Disassembly
Feed Clutch
(PL7.1.20)
Procedure:
1. Remove the 150-sheet feeder assembly (page 8-15).
2. Remove the 550-sheet feeder assembly (page 8-24).
3. Remove the six 8 mm tapping screws that attach the tie plate to the out
chute, and remove the tie plate from the out chute.
4. Unplug the connector (P/J247) of the feed clutch from the tray 2 harness
assembly.
5. Remove the E-ring that secures the feed clutch, and slide the assembly
off the feed shaft.
1.Out chute 3. Feed clutch
2.Tie plate
s4500-106
1
2
3