Xerox Phaser 4510 - Fuser Assembly

8-44 Phaser 4500/4510 Service Manual
FRU Disassembly
Fuser Assembly
N
o
t
e
The fuser used in the Phaser 4510 is different than the fuser used in the
Phaser 4500. The fusers are NOT interchangeable.
(PL8.1.20)
Procedure:
W
arn
i
ng
The fuser assembly is very hot immediately after the printer is turned off.
To avoid possible burns, wait to remove the fuser until it cools down
sufficiently to be handled.
1. Open the paper exit rear door (page 8-5).
2. Push down the left and right fuser levers in the direction of the arrow to
release the fuser assembly locks.
3. Pull the fuser assembly out the back of the printer as indicated by the
arrow.
1.Right fuser lever 3.Fuser assembly
2.Left fuser lever
s4500-119
1
2
3