Xerox Phaser 4510 - Main Fan (P4500)

8-68 Phaser 4500/4510 Service Manual
FRU Disassembly
Main Fan (P4500)
(PL12.1.10)
Procedure:
1. Remove the paper exit rear door (page 8-5).
2. Remove the rear cover (page 8-6).
3. Disconnect the connector (P/J244) of the main fan from the tray 1 harness
assembly.
4. Remove the two screws (tapping, 30 mm) that attach the main fan to the
frame.
Replacement Note:
■ When installing, make sure the harness wires are not pinched between
the main fan and the frame, and make sure the label faces the outside.
1.Main fan 2.Label
s4500-147
2
1