Xerox Phaser 4510 - Front Duct, Sub Fan

8-36 Phaser 4500/4510 Service Manual
FRU Disassembly
Front Duct, Sub Fan
(PL8.1.4) (PL8.1.5)
Procedure:
1. Remove the front cover (page 8-11). Removing the front cover requires
removing all other printer covers and the paper exit assembly.
2. P4510: Remove the vacuum duct (page 8-35).
3. Remove the three screws (one machine with flange, 8 mm; two tapping,
8 mm) that attach the front duct.
4. Unplug the sub fan harness from the LVPS harness assembly at
connector P/J270.
5. Release the fan wires from the cable slot.
6. Remove the front duct (with the sub fan attached) from the frame by
moving it in the direction of the arrow.
1.Front duct 2.Front tie plate
s4510-112
2
P270
J270
1