Xerox Phaser 4510 - DC-DC Converter (P4500)

Phaser 4500/4510 Service Manual 8-63
FRU Disassembly
3. Disconnect the harness connector from P101 on the exit motor PWBA.
4. Unplug the inline harness connector at P/J 404.
5. Disconnect the harness connectors from the connectors (P/J40, 41, 42,
43, 44, 45, 46, 47 and 48) on the LVPS.
6. Remove the five 6 mm screws that attach the LVPS to the frame.
7. Remove the LVPS.
DC-DC Converter (P4500)
(PL 12.01.AA)
Procedure:
1. Remove the front cover (page 8-11).
2. Unplug the cable connectors at P401, P402, and P403.
3. Remove the two 6 mm machine screws and lift out the board.
1.DC-DC converter
s4500-262
1
P402
P401
P403