Phaser 4500/4510 Service Manual 8-91
FRU Disassembly
Feed Clutch Assembly
(PL20.2.21)
Procedure:
1. Remove the optional 550-sheet paper feeder (page 8-78).
2. Remove the six screws (tapping, 8 mm) that attach the tie plate.
3. Remove the tie plate from the out chute.
Note
The connector in the following step has a gender adapter that could
stay with either side of the harness.
4. Disconnect the connector (P/J853) of the feed clutch assembly from the
clutch sensor 1 assembly harness.
5. Remove the E-ring that secures the feed clutch assembly, and remove the
feed clutch assembly from the feed shaft.
Replacement Note:
■ The connectors for the feed clutch assembly and the turn roller clutch are
identical. Be careful to plug in the correct connector.
1.Out chute 3.Tie plate
2.Feed clutch assembly
s4500-165
1
2
3
P/J853
To Next Page
Loading...
