8-90 Phaser 4500/4510 Service Manual
FRU Disassembly
3. Remove the left holder from the nudger support. At the same time, the no
paper actuator is removed.
Note
When handling the nudger roller or nudger gear, avoid touching the
rubber surfaces of the rollers.
4. Release the hook of the nudger roller, and pull it out from the nudger
shaft.
5. Release the hook of the nudger gear, and pull it out from the nudger shaft.
Replacement Notes:
■ Be sure to install the shafts on both ends of the no paper actuator into the
left holder and nudger support.
■ Assemble the hook of the no paper actuator with the left holder as shown
in the figure.
To Next Page
Loading...
