Xerox Phaser 4510 - Tray 3 Failure;Tray 3 or 4 Failure

3-54 Phaser 4500/4510 Service Manual
Error Messages and Codes
Tray 3 Failure/Tray 3 or 4 Failure
No recognition of the optional 550-sheet feeder.
Diagnostic Error Codes
E11-1: Tray 3 failure
E11-2: Tray 3 or 4 failure
N
o
t
e
This procedure assumes that optional 550-sheet paper feeders are
installed as tray 3 and tray 4.
Troubleshooting Reference
Applicable Parts Wiring and Plug/Jack Map References
■ LVPS
■ HVPS/engine logic board
■ 550-sheet feeder PWBA
■ Feeder harness 2
■ Feeder harness 5
■ “550-Sheet Feeder General Wiring Diagram” on
page 10-32
■ “550-Sheet Feeder Signal Diagram” on
page 10-33
■ “550-Sheet Feeder Plug/Jack Locator” on
page 10-12
Troubleshooting Procedure
Steps Actions and Questions Yes No
1 Check feeder harness 2 of the tray 3
feeder:
1.Remove the optional 150-sheet
paper feeder.
2.Disconnect P/J2083.
3.Check the following for continuity:
■ J2083-1 <=> J83-10
■ J2083-2 <=> J83-9
■ J2083-3 <=> J83-8
■ J2083-4 <=> J83-7
■ J2083-5 <=> J83-6
Is each continuous?
Go to “Optional
550-Sheet
Feeder PWBA
(Tray 3)” on
page 4-39, or
go to step 2 if
Tray 4 is not
recognized.
Replace feeder
harness 2.