Xerox Phaser 4510 - Rear Cover

8-6 Phaser 4500/4510 Service Manual
FRU Disassembly
Rear Cover
(PL 1.1.3)
Procedure:
1. Remove the paper exit rear door (page 8-5).
2. Remove the duplex unit if one is installed (page 8-95).
3. Phaser 4500: Remove the three screws (two flanged machine, 8 mm;
one tapping, 8 mm) that attach the rear cover to the printer.
Phaser 4510: Remove the five screws (two flanged machine, 8 mm; three
tapping, 8 mm) that attach the rear cover to the printer.
4. Swing out the left end of the door, then disengage the three hooks on the
right side and move the door away from the printer as indicated in the
illustration.
5. Phaser 4510: Unplug the rear fan harness.
Replacement Notes:
■ Two screw types are used; be sure to install them in the correct locations.
■ When installing a replacement rear door, transfer the foam seals from the
old door to the new.
s4510-0
5
P4500
P4510