Phaser 4500/4510 Service Manual 8-113
FRU Disassembly
Stacker Cover
(PL23.1.1)
Procedure:
1. Remove the stacker from the printer (page 8-111)
2. Remove the stacker rear cover (page 8-112).
3. Remove the weight.
4. Disengage both left flapper hinges from the stacker cover.
5. Disengage the link attached to the left flapper from the stack full shaft.
6. Disengage both right flapper hinges from the stacker cover.
7. Disengage the link attached to the right flapper from the stack full
actuator.
8. Remove the four 8 mm tapping screws, two on the rear and two on the
bottom of the stacker, that attach the stacker cover to the stacker.
9. Rotate the stacker tray up until it contacts the top of the stacker cover.
1.Weight 4.Link
2.Left flapper 5.Stack full shaft
3.Hinge 6.Stack full actuator
s4500-202
1
6
5
4
2
3
To Next Page
Loading...
