Xerox Phaser 4510 - Network Problems

3-20 Phaser 4500/4510 Service Manual
Error Messages and Codes
Network Problems
The printer maintains four (P4510) or six (P4500) logs in memory detailing
network functions. The logs contain TCP/IP, NetWare (P4500 only) and
AppleTalk initialization events. The logs can also be accessed remotely via
CentreWare.
The logs list events chronologically. The log is limited in length; when the log
is full the printer stops recording data to the log. The logs are stored on the
hard drive so only new data is stored each time the printer’s power is cycled.
There is a Connection Setup Page, Configuration Page and a network reset
available for troubleshooting Network problems.
To Print an Event Log or Runtime Log:
1. P4500: From the main menu, select the Troubleshooting Menu, then
select Network Log Pages.
P4510: From the main menu, select the Troubleshooting Menu, then
Network Problems, then Network Log Pages.
2. Highlight the appropriate menu item from the list and select the OK
button.
3. The page should now print.