Xerox Phaser 4510 - Page 308

8-28 Phaser 4500/4510 Service Manual
FRU Disassembly
6. Lift the boss of the left holder at the back of the 550-sheet feeder
assembly, then shift the left holder in the direction of the arrow to release
the three hooks.
7. Remove the left holder and no paper actuator from the nudger support.
8. Release the hook retaining the nudger roller, and slide it off the nudger
shaft.
9. Release the hook retaining the nudger gear, and slide it off the nudger
shaft.
Replacement Note:
■ After the no paper actuator is replaced, manually operate it to verify that it
moves smoothly.