8-22 Phaser 4500/4510 Service Manual
FRU Disassembly
6. Remove the 8 mm screw that attaches the no paper sensor holder.
7. Remove the no paper sensor holder from the 150-sheet feeder assembly.
8. Release the hooks that secure the no paper sensor to the no paper
sensor holder, and remove the no paper sensor.
9. Unplug the cable connector (P/J240) from the no paper sensor.
Replacement Note:
Caution
Use care when tightening the screw on the sensor holder to avoid
pinching and possibly damaging the wires in the cable harness.
To Next Page
Loading...
