Xirrus XR Series User Manual

Wireless Access Point
Viewing Status on the Wireless AP 97
Content of the Access Point Summary Window
The Access Point Summary window is sub-divided into the Ethernet Interfaces
section and the Integrated Access Point (radio) section, providing you with the
following information:
 Ethernet Settings Summary
This section provides information about network interface devices. To
make configuration changes to these devices, go to “Interfaces” on
page 170.
• Interface: Lists the network interfaces that are available on the AP.
• State: Shows the current state of each interface, either enabled or
disabled.
• Mgmt: Shows whether AP management traffic is allowed on this
interface.
• Auto Neg: Shows whether auto-negotiation is in use on this interface,
to determine settings for speed, parity bits, etc.
• LED: Shows whether LED display of interface status is enabled.
• Link: Shows whether the link on this interface is up or down.
• Duplex: Shows whether full duplex mode is in use.
• Speed: Shows the speed of this interface in Mbps.
• MTU Size: Shows the Maximum Transmission Unit size that has
been configured. This is the largest packet size (in bytes) that the
interface can pass along.
• DHCP: Shows whether DHCP on this port is enabled or disabled.
• IP Address: Shows the current IP address assigned to each network
interface device.
• Subnet Mask: Shows the subnet mask, which defines the number of
IP addresses that are available on the routed subnet where the AP is
located.
• Gateway: Shows the IP address of the router that the AP uses to
transmit data to other networks.

Xirrus XR Series Specifications

General

Brand	Xirrus
Model	XR Series
Category	Wireless Access Point
Language	English