Wireless Access Point
434 The Command Line Interface
administrator assign a reserved address to the AP for ease of access in
the future.
• If the network does not use DHCP, use the factory default address
10.0.2.1 to access either the Gigabit 1 or Gigabit 2 Ethernet port. You
may need to change the IP address of the port on your computer that
is connected to the AP — change that port’s IP address so that it is on
the same 10.0.2.xx subnet as the AP port.
2. At the login prompt, enter your user name and password (the default for
both is admin). Login names and passwords are case-sensitive. You are
now logged in to the AP’s Command Line Interface.
Figure 211. Logging In
To Next Page
Loading...
Need help?
General
