Wireless Access Point
Configuring the Wireless AP 297
AirWatch
Active IAPs
By default, when a new SSID is created, that SSID is active on all IAPs. This
window allows you to specify which IAPs will offer that SSID. Put differently,
you can specify which SSIDs are active on each IAP.
This feature is useful in conjunction with WDS. You may use this window to
configure the WDS link IAPs so that only the WDS link SSIDs are active on them.
Figure 159. Setting Active IAPs per SSID
Procedure for Specifying Active IAPs
1. SSID: For a given SSID row, check the IAPs that should offer that SSID to
clients. Uncheck any IAPs which should not offer that SSID.
2. All IAPs: This button, in the last column, may be used to allow or deny
this SSID on all IAPs, i.e., switch all IAPs between allow or deny.
3. All SSIDs: This button, in the bottom row, may be used to allow or deny
all SSIDs on this IAP.
4. Toggle All: This button, on the lower left, may be used to allow or deny
all SSIDs on all IAPs.
5. Click the Save button if you wish to make your changes permanent.