Wireless Access Point
112 Viewing Status on the Wireless AP
You may sort the rows based on any column that has an active column header,
indicated when the mouse pointer changes to the hand icon . Click Refresh to
update the information at any time. Click Auto Refresh to instruct the AP to
refresh this window automatically.
See Also
Filters
CDP List
This status-only window lists devices on the AP’s network that support the Cisco
Discovery Protocol (CDP).
Figure 58. CDP List
The AP performs discovery on the network on an ongoing basis. This list shows
the devices that have been discovered — Cisco devices and other devices on the
network that have CDP running. For each, it shows the device’s host name, IP
address, manufacturer and model name, the device interface that is connected to
the network (i.e., the port that was discovered), and the network capabilities of
the device (switch, router, supported protocols, etc.).
CDP must be enabled on the AP in order to gather and display this information.
For details and some restrictions, see “Cisco Discovery Protocol (CDP) Settings”
on page 181.
To Next Page
Loading...
Need help?
General
