Wireless Access Point
Configuring the Wireless AP 237
Management Control
This window allows you to enable or disable the AP management interfaces and
set their inactivity time-outs. The range is 300 (default) to 100,000 seconds.
Figure 135. Management Control
Procedure for Configuring Management Control
1. Management Settings:
a. Maximum login attempts allowed (1-255): After this number of
consecutive failing administrator login attempts via ssh or telnet, the
Failed login retry period is enforced. The default is 3.
b. Failed login retry period (0-65535 seconds): After the maximum
number (defined above) of consecutive failing administrator login
attempts via ssh or telnet, the administrator’s IP address is denied
access to the AP for the specified period of time (in seconds). The
default is 0.
c. Pre-login Banner: Text that you enter here will be displayed below
the WMI login prompt. (Figure 136) Click the Submit button when
done typing.
If you wish to display more than 256 characters of text (for instance,
to display usage restrictions for the wireless network), you may
To Next Page
Loading...
Need help?
General
