Wireless Access Point
522
8. If you need to edit any of the SSID settings, you can do so from
the SSID Management page.
See Also
General Hints and Tips
Security
SSIDs
SSID Management
VLAN Support
Security
Q. How do I ensure that I meet FIPS requirements?
A. To meet the Level 2 security requirements of FIPS 140-2, follow the
instructions in “Implementing FIPS Security” on page 599.
Q. How do I configure the AP for PCI DSS auditing?
A. A. To audit PCI DSS requirements, follow the instructions in “Auditing
PCI DSS” on page 593.
Q. How do I know my management session is secure?
A. Follow these guidelines:
Administrator passwords
Always change the default administrator password (the default
is admin), and choose a strong replacement password. When
appropriate, issue read only administrator accounts.
SSH versus Telnet
Be aware that Telnet is not secure over network connections and
should be used only with a direct serial port connection. When
connecting to the unit’s Command Line Interface over a network
connection, you must use a Secure SHell (SSH) utility. The most
commonly used freeware providing SSH tools is PuTTY. The AP
only allows SSH-2 connections, so your SSH utility must be set
up to use SSH-2.
To Next Page
Loading...
Need help?
General
