Wireless Access Point
Viewing Status on the Wireless AP 113
LLDP List
This status-only window lists devices on the AP’s network that support the Link
Layer Discovery Protocol (LLDP).
Figure 59. LLDP List
The AP performs discovery on the network on an ongoing basis. This list shows
the devices that have been discovered — devices on the network that have LLDP
running. For each, it shows the device’s host name, IP address, and model name,
the device interface that is connected to the network (i.e., the port that was
discovered), and the network capabilities of the device (switch, router, supported
protocols, etc.).
LLDP must be enabled on the AP in order to gather and display this information.
For details and some restrictions, see “LLDP Settings” on page 182.
Network Assurance
This status-only window shows the results of ongoing network assurance testing.
Figure 60. Network Assurance
The AP checks connectivity to network servers that you have configured (for
example, DNS and NTP servers) on an ongoing basis. For each server, this list
shows the server’s host name (if any), IP address, and status.
To Next Page
Loading...
Need help?
General
