Wireless Access Point
Configuring the Wireless AP 381
RSSI of client = -75ï€
-75 < (-5 + -65) : Therefore client will roamï€
Another example:
Threshold = -15
RSSI of neighbor AP = -60
RSSI of station = -70
-70 > (-15 + -60) : Client will not roam
Figure 184. Roaming Assist
Procedure for Configuring Roaming Assist
1. Enable Roaming Assist: Use the Yes and No buttons to enable or disable
this feature.
2. Backoff Period: After deauthenticating a station, it may re-associate to
the same radio. To prevent the AP from repeatedly deauthenticating the
station when it comes back, there is a backoff period. This is the number
of seconds the station is allowed to stay connected before another
deauthentication.
To Next Page
Loading...
Need help?
General
