Wireless Access Point
Installing the Wireless AP 67
Installation Workflow
This workflow illustrates the steps that are required to install and configure the
AP successfully. Review this flowchart before attempting to install the unit on a
customer’s network. Cloud XMS customers will skip the last two steps.
Figure 30. Installation Workflow
See Also
Coverage and Capacity Planning
Common Deployment Options
Determine the number of Arrays needed
Choose the location(s) for your Wireless Arrays
Install the mounting plate
Connect the cables and turn on the power
Verify that the Ethernet link and radio LEDs are functioning correctly
Review the Array Configuration
Run Ethernet cables for PoGE
(<100m total distance from switch)
Log in to WMI
To Next Page
Loading...
Need help?
General
