Wireless Access Point
Configuring the Wireless AP 261
after you have made a change requiring validation (i.e., entering a new
hostname or changing an existing entry to a different hostname). If you
return to this page at a later time, the checkmark will not be present.
5. Workgroup/Domain: Enter the Pre-Windows 2000 Domain name. This
can be found by opening the Active Directory Users and Computers.
Right click the domain in the left hand window and select Properties.
This will display the Domain name that should be entered.
Figure 146. Finding the Domain Name from Active Directory
6. Realm: Realm name (may be the same as the domain name). Workgroup
and Realm are both required. To find the Realm, open a command
window on the server and type
echo %userdnsdomain%
This will display the Realm.
7. Click Apply Active Directory Settings to use these settings.
8. You must click Join Domain to ask the domain controller to join the AP to
the domain. The AP is added to the list of computers in the workgroup.
The status of the request will be displayed in the area below the Test
To Next Page
Loading...
Need help?
General
